Lower temperatures will increase derusting times. When using Jenolite Rust Removers it is important that the metal surface treated is between 15 – 25 deg.c. The products are wiped dry immediately after immersion. The degreased components are immersed in Jenolite Liquid, used as supplied until all the rust has been removed. A polythene tank can be used for immersion at ambient temperature. Jenolite Liquid can be used to derust components by immersion. When using epoxy paints or two packs it is advisable to use the products as for body fillers. Primers must also be compatible with top coats. If in doubt, wipe the Jenolite treated surface with a cloth and warm water and dry immediately.Ĭheck the compatibility of all products that are to be used after derusting. If body fillers are used on Jenolite treated surfaces it is essential that all chemicals have been wiped away. Splashes onto surrounding paintwork and skin may cause staining – wash off immediately with water.Ĭonsult Safety Data Sheet for more information. Wash brushes and equipment in clean water immediately after use. If in doubt test a small area first.ĭo not return excess Jenolite Rust Remover to the container. READY TO PRIME IN 30 MINUTES After wiping dry, wait for 30 minutes, then apply Jenolite Primer or topcoat. Wipe dry immediately with a clean lint-free cloth. Leave until the rust has been removed, drain excess liquid for one minute. To ensure all rust has been successfully removed, brush away the dark grey residue with a wire brush/steel wool (if rust is still present thereafter, repeat the process as above until all rust has been removed).įOR IMMERSION Small components can be immersed in a plastic container. Continue this process until all visible rust has turned dark grey in colour, at which point, wipe the surface dry with a clean, lint-free cloth. Vertical surfaces may require the most attention. Do not allow the surface to dry out or become tacky. Keep Jenolite active by working in with a brush every 5 minutes and adding more if required. Brush liberally, directly onto rusty areas only. Remove old paint and loose rust with steel wool or wire brush.ĪPPLY DIRECTLY TO RUST Pour the required amount into a plastic container.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |